Talk:Proxy ARP

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

Lead[edit]

I made a couple changes to help clear up the intro a little bit, per the below concern. To answer your technical concern: The issue you raise is not valid. Proxy ARP is not necessary for devices on the same ethernet network, because on a standard ethernet if two devices are in the same subnet and one sends an ARP for the other, the intended device is more than willing to respond to that ARP request directly. Proxy ARP works when a router or server sits between two networks, and has a MAC entry that matches the ARP request. It supplies it's own MAC address in response to the request, and simply routes the traffic to the correct destination. I hope that clears up some of the confusion. ~mtzweil


Could the opening sentence be any less clear?

In the introduction section it says proxy arp is used to communicate between two different networks. I think it is wrong. ARP is used only within the same subnet. If Host A wants to reach Host B on a different network, it will arp for the gateways ip address and not for Host B's address. —Preceding unsigned comment added by Sanjaysr (talkcontribs) 14:56, 20 March 2008 (UTC) —Preceding unsigned comment added by 122.164.54.124 (talk) [reply]

I made some further clarifications. ~Kvng (talk) 15:17, 9 February 2021 (UTC)[reply]

ARP Simulation visualizes[edit]

The following discussion is closed. Please do not modify it. Subsequent comments should be made on the appropriate discussion page. No further edits should be made to this discussion.


The link to 'ARP Simulation visualizes' is a deadlink and needs to be removed - Chris — Preceding unsigned comment added by 82.33.218.74 (talk) 13:27, 28 November 2012 (UTC)[reply]

The discussion above is closed. Please do not modify it. Subsequent comments should be made on the appropriate discussion page. No further edits should be made to this discussion.